HDPE Heat shrink crimp seal connector/butt splice
- BrandDEEM
- TypeDC-SC
Heat Shrinkable splices provide a permanent environmental seal.
The polymer used in the production of the heat shrink tube is specially adapted to be crimped. Ideal for electrical equipment repairs, maintenance and outdoor electrical cabling.
Features
Operating temperature: -55°C to +125°C
Minimum shrink temperature: 110°C
No wire damage thanks to a lower shrink temperature.
100% waterproof, excellent fluid resistance. Very high abrasion resistance.
Color: Red, Blue, Yellow
Shrink ratio: 3:1.
Technical Data
Property
Test Method
Typical Data
Tensile Strength
ASTM D 2671
28MPA(min)
Elongation at break
ASTM D 2671
500%(min)
Longitudinal Shrinkage
UL224
0 to-10%
Heat Shock
250°C/4hrs.
No cracking, Flowing of out wall
Heat resistance
165℃/168hrs.
No cracking, Flowing of out wall
Cold bend(-40C/1hr.)
ASTM D 2671
No cracking
Voltage withstand (AC 2500V,60 sec.)
ASTM D 2671
No Breakdown
Volume Resistivity
ASTM D 876
1014Ω.cm
Copper corrosion
UL 224
Pass
Water absorption
ASTM D570
≤0.5%
Fluid resistance (23°C/24 hrs)
ASTM D 2671
Good to excellent
Specific Gravity
ASTM D 792
1.01g/cm3
| DC-SC | Wire range | AWG | As supplied (mm) | After recovery (mm) | |
| Inside diameter | Inside diameter | Cut length(mm) | |||
| Light Yellow Clear | 0.1-0.5mm2 | 26-24 | 3.0 | 1.0 | 26 |
| Red | 0.5-1.5mm2 | 22-18 | 4.5 | 1.5 | 38 |
| Blue | 1.5-2.5mm2 | 16-14 | 5.5 | 1.8 | 38 |
| Yellow | 4-6mm2 | 12-10 | 6.5 | 2.2 | 42 |
Installation instructions
1- Select butt splice to suit conductor size.2- Strip insulation to 8mm and insert into the splice barrel.
3- Crimp using the correct tool for pre-insulated splices (tool recommended : DM-CRIMP SEAL TOOL)
4- Apply heat to the crimp seal with hot air gun until tubing recovers and the adhesive flows from the end of the splice.
